Fyne Audio F1-10 Speaker

The Fyne Audio F1.10 speaker is equipped with a 250mm Iso Flare coaxial mid/woofer. Iso Flare is a point source system in which the speaker driver shares a common center with the high frequency unit. This unique structure in the speaker helps preserve harmony when encountering complex musical passages, creating the most realistic sound stage. In addition, the sound is generated from a single point, concentrating energy at the crossover point, the speaker will also not depend on the placement.

The high frequency section features a 3-inch, high-rigidity titanium HF for smooth performance. Combined with a large 76,2mm diameter Neodymium magnet, the vented rear chamber places the low frequency resonance below the crossover. The crossover point is very low at 750Hz, providing a more realistic soundstage, reproducing the artists' voices more clearly.

To achieve flat frequency response and avoid internal reflections, Fyne Audio F1.10 speaker The extended-ratio annular waveguide has been used. On the low frequency part, the multi-fiber paper cone contributes to the natural and airy, clear midrange. The LF motor system has been used ferrite magnets with copper windings on aluminum substrate to support the best power dissipation. This is the complete unit built in a rigid die-cast aluminum frame to eliminate unwanted vibrations and damp compliance.

The unique stand of the Fyne Audio F1.10 speaker weighs 16kg, supporting and protecting the speaker from vibrations. In addition, this stand is also a special part to complete the ventilation system at the bottom of the speaker cabinet. Below the vent at the bottom of the speaker, the BassTrax Tractrix diffuser is used to convert single waves into 360-degree spherical waves. This helps to diffuse sound energy evenly throughout the room and is also not picky about the speaker placement.

This Tractrix configuration was previously commonly used for horn speakers in the 1920s, but when applied to a diffuser of this type it attracted the attention of experts and was considered unique.

The Fyne Audio F1.10 speaker crossover uses high-quality, precision components including LF multi-layer core inductors, non-inductive thick-film resistors, and HF polypropylene capacitors. This design has been optimized, fine-tuned, and rigorously tested. In addition, the speaker's WBT Nextgen bio-wire connectors are also gold-plated, and the Neotech PC-OCC wiring system provides high-transparency signal transmission.